Due to the subtropical monsoon climate in most parts of China, the summer is hit by typhoons and other winds, which have caused significant damage to these relatively high but relatively weak streetlights. The phenomenon of solar street light panels falling, lamps falling, and lamp poles tilting to topple often occurs, which cannot provide normal lighting effect and poses great problems for pedestrians and vehicles on the road
Therefore, we need to conduct a comprehensive inspection of solar and LED street lights before the wind approaches. Visiting the site to see if there is any shaking of the battery panel and lighting fixtures, whether the street lights are skewed, and whether the bolts of the foundation cage are loose.
As the temperature increases, the energy storage of the battery is also affected. We should promptly detect past batteries and replace solar batteries with ones that do not meet the requirements of operation to avoid affecting normal operations.
Check the water resistance performance of the system. Turn on the bottom of the streetlight and the solar controller to check for contact, water seepage, tape falling, and other conditions at each joint.
If there is any, it should be rectified in time. Due to the large increase of rainfall in summer, although the rainwater generally does not enter the lamp post, the condensation of water vapor is also in a short circuit condition. In addition, there are many rainstorm in summer, and the ponding often appears, which is very meaningful.
Article source: Solar street lamp manufacturer Www.mingsongled.com
11-18
Common dimming methods for LED lamps from Zhongshan LED lamp manufacturers
There are currently several methods for intelligent control and dimming:1、 Leading edge phase control dimmingThe principle is to adjust the conduction angle of each half wave of communication electric
11-18
What are the common wiring methods for outdoor LED lamps from Zhongshan LED lamp manufacturers
The primary consideration for wiring outdoor LED lighting fixtures is the usage environment. There are many factors to consider in the field, such as dust prevention, temperature resistance, and ag
11-18
Six main reasons and solutions for the low brightness of LED lamps produced by Zhongshan LED lamp manufacturers at night
There are six main reasons and solutions for LED lamps to light up slightly after turning off at night. At present, LED has fully replaced halogen and fluorescent light sources due to its advantage
11-18
What are the requirements for lamp poles for solar street lamps mentioned by solar street lamp manufacturers
1. Street lamp inspection standards that comply with current regulations.2. The parameters, dimensions, and appearance of the lamp pole and lamp are shown in the drawings.3. The inner and outer surfac