There are six main reasons and solutions for LED lamps to light up slightly after turning off at night. At present, LED has fully replaced halogen and fluorescent light sources due to its advantages of energy conservation, high brightness, and long lifespan.
LED light sources have low excitation current and are appropriately sensitive to voltage and current. During use, they can cause induced luminescence due to various complex reasons. Even after turning off the lights, they will emit low light, affecting normal sleep and accelerating the light decay of the lamps. Generally, it is caused by the following reasons:
1、 The switch operates the zero line.
This is a common reason, as the electrician manipulated the zero line during wiring, or perhaps the zero fire connection was reversed when the electrical box was wired in. The switch controls the zero line, and if it is still connected to the lamp in front, it will emit a faint light. Solution: Adjust the wiring and allow the switch to operate the front.
2、 Dual control switch presents incorrect connection method
There are several wiring methods for dual control switches, and if the wrong method is used, the lights will also turn off and light up slightly. Solution: Install the normal control front connection method and wire it from scratch.
3、 Switch with indicator light, using electronic switches
There is an indicator light inside the switch, and after turning off the light, there will be a slight current flowing through it. If the lamp uses electronic switches, such as infrared, voice control, and remote control switches. There will also be a phenomenon of shimmering after turning off the lights.
Solution 1: Change the switch.
Solution 2: Connect a 500K resistor in parallel at the inlet of the lamp. However, this method requires high technical requirements and is not easy to operate by non specialized personnel. Moreover, if the zero line is charged, the shimmering caused by patch leakage may not be effective.
Article source: Zhongshan LED Lamp Manufacturer Www.mingsongled.com
11-18
Common dimming methods for LED lamps from Zhongshan LED lamp manufacturers
There are currently several methods for intelligent control and dimming:1、 Leading edge phase control dimmingThe principle is to adjust the conduction angle of each half wave of communication electric
11-18
What are the common wiring methods for outdoor LED lamps from Zhongshan LED lamp manufacturers
The primary consideration for wiring outdoor LED lighting fixtures is the usage environment. There are many factors to consider in the field, such as dust prevention, temperature resistance, and ag
11-18
Six main reasons and solutions for the low brightness of LED lamps produced by Zhongshan LED lamp manufacturers at night
There are six main reasons and solutions for LED lamps to light up slightly after turning off at night. At present, LED has fully replaced halogen and fluorescent light sources due to its advantage
11-18
What are the requirements for lamp poles for solar street lamps mentioned by solar street lamp manufacturers
1. Street lamp inspection standards that comply with current regulations.2. The parameters, dimensions, and appearance of the lamp pole and lamp are shown in the drawings.3. The inner and outer surfac